August 2, 2017 at 20:19
I have a question about running the naze32 afroflight board with ez-gui. When ever I change a setting and save it to the board my flight controller gets stuck with a blue led and becomes unresponsive until I disconnect and start again :/
August 4, 2017 at 17:32
It depends on the firmware that you have in your flight controller. At he moment I try to support latest betaflight. The app can be not compatible with old firmwares.
October 5, 2015 at 10:12
My phone doesn’t support USB hosting so I have been trying to connect using my tablet which does.
However I just cannot get this app to connect to my Naze. I have tried the 3 USB options.
I did find I had to have the OTG cable plugged into my tablet (rather than the Naze) for the Naze to power up, which means they can at least communicate on that level.
July 15, 2015 at 23:54
bought my third OTG cable. still can’t connect. using cleanflight, afro32, USB. will not connect using any of the available settings.
July 16, 2015 at 01:49
Does your phone support usb host ?
April 9, 2015 at 20:52
I’m trying to find out if this will work with a CC3D board. Sorry I’m new to all this and it looks like this is for the multiwii boards.
May 28, 2015 at 19:07
I’m not sure of it’s compatibility with OpenPilot but it will work with Cleanflight, which can be flash onto a CC3D.
May 28, 2015 at 21:37
It will work with cleanflight on CC3D board. But USB connection at the moment doesn’t work. will be corrected as soon as I receive CC3D board.
July 15, 2015 at 23:41
CC3D now works through USB. You need the EZ-GUI 3.206.206 or later
and also read this: http://ez-gui.com/manual/troubleshooting/#CC3D_throught_USB_OTG_doesn8217t_work
You must be logged in to post a comment.
© 2017 EZ-GUI
Theme by Anders Noren — Up ↑